ECU - Mitsubishi Genuine Part Number MD??????

Gen1 Is NOT Done Yet. Do NOT Use!!!

X-01

Pin #	IN / OUT	Wire size (mm²)	Wire colour	Sheild	Description	Paired with
1	IN	0.85			Injector 1 ground control
2	IN	0.85			Injector 3 ground control
3
4	IN	0.50			Idle speed control servo (coil A1)	17
5	IN	0.50			Idle speed control servo (coil B1)	18
*6					(?) EGR solenoid (* No connection)
7				Y
8	IN	0.50			Fuel pump relay ground control (MFI relay)
10	OUT	0.50			(?) Ignition power transistor A (cyl 1 & 3)	23
11
12	IN	0.50			Power source	108
13	OUT	1.25			Chassis ground
Pin #	IN / OUT	Wire size (mm²)	Wire colour	Sheild	Description	Paired with
14	IN	0.85			Injector 2 ground control
15	IN	0.85			Injector 4 ground control
16
17	IN	0.50			Idle speed control servo (coil A2)	4
18	IN	0.50			Idle speed control servo (coil B2)	5
19
20	IN	0.30			(?) A/C control unit	21
21	IN	0.50			(?) A/C (?? or Fuel pump relay 2)	20
22	IN	0.30			A/C (? A/C clutch relay)
23	OUT	0.50			(?) Ignition power transistor B (cyl 2 & 4)	10
*24					(?) Electric load switch (* No connection)
25	IN	0.50			Power source	108
26	OUT	1.25			Ground ( + O2 sensor wire shielding)

Pin #	IN / OUT	Wire size (mm²)	Wire colour	Sheild	Description	Paired with
101	OUT	0.50			RPM Signal
102
103
104					(?) Ignition timing adjustment
105
106	IN				(?) Check engine light control ground (dash)
107	IN				(?) 5v to powersteering oil pressure switch
108					(?) Engine control relay ground control (turns on 12 & 25)
Pin #	IN / OUT	Wire size (mm²)	Wire colour	Sheild	Description	Paired with
109	IN	0.50			Oil control valve switch ground control (MIVEC solenoid) (? Induction valve open)
110					(?) Induction valve closed
111					(?) Induction valve position sensor 1
112					(?) Diagnostic connector	113;
113					(?) Diagnostic connector	112
114					(?) ABS ECU
115					(?) 5v to engine coolant temperature sensor
116

Pin #	IN / OUT	Wire size (mm²)	Wire colour	Sheild	Description	Paired with
51	IN	1.25			(?) to start
52	OUT	0.50			(?) 5v to air intake temperature sensor
53					(?) EGR temperature sensor
54					(?) No connection
55	IN	0.50		Y	(?) O2 sensor 2 (heated type) (* v6 only, back 3 cyl)
56				Y
57					(?) No connection
58	IN	0.50		Y	(?) Detonation sensor
59					(?) No connection
60	IN	0.50			(?) Battery backup
61	OUT	0.50			(?) 5v to throttle position sensor Atmospheric/Barometric pressure sensor
Pin #	IN / OUT	Wire size (mm²)	Wire colour	Sheild	Description	Paired with
62	IN	1.25			(?) Gets 12v when the key is turned to start
63	OUT	0.50			(?) 5v to engine coolant temperature sensor
64	IN	0.50			(?) Throttle position sensor
65	IN	0.50			(?) Atmospheric/Barometric pressure sensor
66	OUT	0.50			(?) 5v to vechicle speed sensor
67	OUT	0.50			(?) 5v to idle switch (in Throttle position sensor)
68	OUT	0.50			(?) Camshaft position sensor
69	OUT	0.50			(?) Crank angle sensor
70					(?) 5v to air flow sensor
71	OUT	1.25			(?) connected to start
72	IN	0.50			(?) Throttle position sensor Atmospheric/Barometric pressure sensor Engine coolant temperature sensor